I’ve replaced my old laptop with a new one and I have over 350GB worth of data to move over, moving all of it to an external drive and then moving them to the new laptop doesn’t seem efficient and it seems like it’s gonna take forever
I know there are some special cables that can do that but I don’t wanna waste money on something that I’m only gonna use once every 5 years at most.
Lots of people are suggesting network cables and the likes.
But if the data is so valuable you want to migrate it then isn’t it also worth backing it up? I’d buy an external HD, copy the data onto that and then copy it to your new laptop and keep the hard drive somewhere safe as a backup.
I second this. You may as well have a secondary device out there with some sort of backup of your important data.
removed by mod
my home network is quite slow and the ethernet port on my old laptop is damaged, it only works sometimes so it’ll definitely disconnect during the process.
You could try getting an external hard drive/SSD enclosure, putting the hard drive/ssd from your old laptop in it, and plugging it into your new computer to copy the files over. Twice as fast as copying to an external drive and then copying that to the new PC.
Buy a cheap USB to Ethernet adapter then and directly connect the two computers via Ethernet. USB to USB is possible but it’s not worth the time and effort, network will be faster and easier. Or why not just buy a cheap external hard drive? According to Amazon a 500gb external hard drive can be had for $30 USD.
removed by mod
Then use/get a usb data stick and transfer em that way or subsequently if it’s the laptop you want to transfer off of, remove the HDD or SSD and get an adapter to plug the drive into usb.
Look for sata to usb adapters
USB drives are ridiculous these days. 512g for ~$40 USD. And USB 3 can fill it up in like a minute. Plus it’s always handy to have one. Best value option IMO.
By home network, do you mean your internet speed? Because if you do, FYI, your computers and electronics can almost certainly talk to each other over your local network much faster than that.
Do you have a router? I mean something resembling a LAN? If so the outbound network speeds wouldn’t matter.
I do have a router, but I have to use wifi for the old laptop, does it affect the transfer speed?
If you already have a router no need to buy other cables/hardware. It’s a piece of tech specifically design for networking. Just share the drive on the network and go at it. I think average wifi speed is like 1Gbps.
This is the answer.
When you say it’s going to ‘take forever’ how long are we talking? Can you try a small batch and see how long it takes? If you really are only doing this every 5 years or so and don’t want to spend any money then the setup you have may be your best option.
If you want to spend $10 or so you could buy a cat6 Ethernet cable (and you may also need to buy a dongle for the laptop). The transfer would take a few hours.
Depending on your internet speed you could also sign up for a single month of Dropbox and do it that way (again, about $10).
For the quickest (and most expensive way) you could purchase an external nvme/SSD which would do the job in a few minutes. Couple hundred dollars but then you’ve got a very useful device that you can use in future.
As someone else said, either a USB transfer cable or
a USB network adapter and your local network.
If you’re on the same network I would just use Filezilla ftp client. Download it on both devices and you can transfer whatever between them.
Are you planning on keeping the old laptop? If it’s not a proprietary drive type you could probably just take it out and pop it into your new computer. Most newer laptops can support two
SSD. If they’re both M.2 drives you wouldn’t even need a new cable, just a screwdriver.Use an ethernet cord, if youre asking this question then you likely have one lying around. I did it a few months ago, had to jump some hoops like disconnecting from all networks and making folders discoverable to get it working though
If you’re going to directly connect them using just a single cable then it needs to be a crossover cable and he’ll need to set the IP manually on each end. Most people don’t have a crossover cable lying around. It would be easier to plug both computers into a router/switch and do a network transfer or just get a USB adapter for whatever kind of drive is in the old computer.
Edit: it’s been a while since I needed to dot do that and apparently modern Ethernet doesn’t need specialized cables anymore. TIL.
This would probably be the fastest way, OP. I know a lot of laptops don’t have a port for it, but if yours do, then do that.
If speed is your concern, you may also want to try network cable or wifi. You can share, access, and copy files over the network.
For USB, if you can use a USB 3 Port specifically it’ll be faster than USB 2 ports.
I’m not familiar with direct us pc connections. When you connect the two via USB, the OS may ask you what kind of connection it is. One will have to serve as the host or controller, and the other as a device like a storage device.
I’m pretty sure you need something called a “usb transfer cable” which can do the job. It has a special electronic chip in the middle that tricks each PC on either side into thinking the other is a usb stick. (Or something!??)
I’ve never used one, and didn’t know there was such a thing which existed until minutes ago. But like you say - probably a waste to use once.
If one happens to be an Apple brand, they do have something called Target Disk Mode, but assuming not since you say PC.
I think that the problem you run into is that USB isn’t a network of peers. There’s a host, and devices that it talks to. The USB controller circuitry needs to support acting in both device and host mode, and unless something has changed, I don’t think that laptop USB controllers can normally do that.
There are devices with USB controllers that can, like Android devices, which is why you can both plug your phone into a computer as well as attach USB devices to the phone.
I assume that both can handle wireless Ethernet, even if they don’t have wired Ethernet connections. IIRC, there’s an ad-hoc networking mode where one can basically act as a base station for the other. You might look into that. I don’t know what OS you’re using or what support for that is like.
EDIT: I do Linux, but this discusses setup for Windows machines.
https://www.lifewire.com/how-to-set-up-an-ad-hoc-wireless-network-2377459
Once you have them talking to each other via wireless Ethernet, if it’s Windows, there’s a file-sharing feature. If I were doing this between two Linux machines, I’d probably use rsync over ssh.
If you have a base station/wireless access point/broadband router/whatever you want to call it, and you can have both laptops join its network and it can be configured to let both machines see each other, that might cut the ad-hoc network out. I don’t know whether the typical WAP is configured to let devices on the wireless network talk to each other these days, though I suppose that if people have things like printers on their wireless network that have to talk to their computers, they must be.
Without buying any cables, go to toffeeshare.com, select what you need and check the “Share with nearby devices” box to transfer everything over the local network. Just put both PCs on the same wifi network.
What is this magic? And why the hell isn’t direct file sharing built into every device?!
Asking as both computers are plugged into the same network (internet does not matter) you can do this much easier and chances are you’d need a special usb cable to transfer anyways
Unfortunately you would need some kind of electronics in the middle. You can get USB “bridged” or “networking” cables, but they aren’t regular USB cables.
However, the electronics could be a smartphone if you have one. Transfer the files from your old laptop to the phone, then to your new laptop.
Ultimately, networking would be the easiest and fastest way to do it. If you’re on Windows, you could use a program such as FastCopy to verify the files on the receiving end.
use smb ftp sftp or something similar, just make sure both laptops are connected to the router with ethernet. if the old laptop has its storage easily accessible then I might also just take it out and plug it into my sata dock
You could turn it into an external hd or install it in new laptop (assuming you have an extra bay).
I know it’s not an answer to the cable question. But you should really consider sync thing. It’s open source you can run a server on your local network and a client on your other comouter and move all the files over just using your local networking. It’s painless. Open source. End to end encrypted. So in the scenario the special cable would just be Ethernet or Wi-Fi
